ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 119)

Ethernet Switch CLI Reference Guide
119
C
H A P T E R
27
IP Commands
Use these commands to configure the management port IP address, default domain name
server and to look at IP domains.
"
See Chapter 59 on page 209 for static route commands.
"
See Chapter 28 on page 123 for IP source binding commands.
27.1 Command Summary
The following section lists the commands for this feature.
Table 69 ip Command Summary
COMMAND DESCRIPTION M P
show ip Displays current IP interfaces. E 0
ip name-server <ip> Sets the IP address of the domain name server. C 13
ip address <ip> <mask> Sets the IP address of the MGMT port (for out-of-band
management) on the Switch.
E 0
ip address default-gateway <ip> Sets the default gateway for the out-of-band
management interface on the Switch.
C 13
show ip iptable all [IP|VID|PORT] Displays the IP address table. You can sort the table
based on the IP address, VLAN ID or the port number.
E 3
show ip iptable count Displays the number of IP interfaces configured on the
Switch.
E 3
show ip iptable static Displays the static IP address table. E 3
Table 70 tcp and udp Command Summary
COMMAND DESCRIPTION M P
show ip tcp Displays IP TCP information. E 3