2 command summary – ZyXEL Communications ZyXEL Dimension ES-2024PWR User Manual
Page 130
Chapter 30 Link Layer Discovery Protocol (LLDP) Commands
Ethernet Switch CLI Reference Guide
130
30.2 Command Summary
The following section lists the commands for this feature.
Table 76 lldp Command Summary
COMMAND
DESCRIPTION
M
P
interface port-channel
port(s).
C
13
lldp admin-status
Sets LLDP operating mode.
tx-only: the port(s) can only send LLDP packets.
rx-only: the port(s) can only receive LLDP packets.
tx-rx: the port(s) can send or receive LLDP packets.
C
13
lldp basic-tlv management-
address
Enables the sending of Management Address TLVs on
the port(s).
C
13
lldp basic-tlv port-description Enables the sending of Port Description TLVs on the
port(s).
C
13
lldp basic-tlv system-
capabilities
Enables the sending of System Capabilities TLVs on the
port(s).
C
13
lldp basic-tlv system-
description
Enables the sending of System Description TLVs on the
port(s).
C
13
lldp basic-tlv system-name
Enables the sending of System Name TLVs on the
port(s).
C
13
lldp notification
Enables the sending of LLDP traps.
C
13
lldp org-specific-tlv dot1
port-protocol-vlan-id
Enables the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs, which contains the VLAN ID and
indicates whether the VLAN is enabled and supported.
C
13
lldp org-specific-tlv dot1
port-vlan-id
Enables the sending of IEEE 802.1 Port VLAN ID TLVs,
which contains the port’s VLAN ID.
C
13
lldp org-specific-tlv dot3
link-aggregation
Enables the sending of IEEE 802.3 Link Aggregation
TLVs, which shows the link aggregation status of the
port(s).
C
13
lldp org-specific-tlv dot3 mac-
phy
Enables the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLV, which shows duplex and rate
settings and indicates whether auto negotiation is
supported on the port.
C
13
lldp org-specific-tlv dot3 max-
frame-size
Enables the sending of IEEE 802.3 Maximum Frame
Size TLVs on the port(s).
C
13
lldp org-specific-tlv dot3
power-via-mdi
Enables the sending of IEEE 802.3 Power via MDI TLVs,
which indicates whether power can be supplied via a
media dependent interface (MDI) on the port(s).
C
13
no lldp admin-status
Sets the port(s) to not send or receive LLDP packets.
C
13
no lldp basic-tlv management-
address
Disables the sending of Management Address TLVs on
the port(s).
C
13
no lldp basic-tlv port-
description
Disables the sending of Port Description TLVs on the
port(s).
C
13
no lldp basic-tlv system-
capabilities
Disables the sending of System Capabilities TLVs on the
port(s).
C
13
no lldp basic-tlv system-
description
Disables the sending of System Description TLVs on the
port(s).
C
13