ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 102)

Chapter 22 IGMP and Multicasting Commands
Ethernet Switch CLI Reference Guide
102
22.3 Command Examples
This example configures IGMP on the Switch with the following settings:
• Sets the Switch to flood unknown multicast frames.
• Sets the Switch to non-querier mode.
ip igmp robustness-variable <2-255> Sets the IGMP robustness variable on the
Switch. This variable specifies how susceptible
the subnet is to lost packets.
C 13
ip igmp query-interval Sets the igmp query interval on the Switch.
This variable specifies the amount of time in
seconds between general query messages
sent by the router.
C 13
ip igmp query-max-response-time <1-25> Sets the maximum time that the router waits
for a response to a general query message.
C 13
ip igmp last-member-query-interval <1-
25> Sets the amount of time in seconds that the
router waits for a response to a group specific
query message.
C 13
no ip igmp Disables IP IGMP in this routing domain. C 13
show ip igmp group DIsplays the multicast groups learned by
IGMP.
E 3
show ip igmp interface Displays the IGMP status information per
interface.
E 3
show ip igmp multicast Displays the multicast traffic information. E 3
show ip igmp timer Displays the IGMP timer settings. E 3
show router igmp Displays global IGMP settings. E 3
Table 59 IPMC Command Summary
COMMAND DESCRIPTION M P
interface port-channel <port-list> Enters config-interface mode for the specified
port(s).
C 13
ipmc egress-untag-vlan <vlan-id> Sets the Switch to remove the VLAN tag from
IP multicast packets belonging to the specified
VLAN before transmission on this port.
Enter a VLAN group ID in this field. Enter 0 to
set the Switch not to remove any VLAN tags
from the packets.
C 13
no ipmc egress-untag-vlan Disables the ports from removing the VLAN
tags from outgoing IP multicast packets.
C 13
Table 58 IGMP Command Summary (continued)
COMMAND DESCRIPTION M P