2 command examples – ZyXEL Communications ZyXEL Dimension ES-2024PWR User Manual
Page 253
Chapter 73 Additional Commands
Ethernet Switch CLI Reference Guide
253
73.2 Command Examples
This example checks the cable pairs on port 7.
traceroute <ip|host-name> [vlan
<vlan-id>] [ttl <1-255>] [wait
<1-60>] [queries <1-10>]
Determines the path a packet takes to the specified Ethernet
device.
vlan <vlan-id>: Specifies the VLAN ID to which the
Ethernet device belongs.
ttl <1-255>: Specifies the Time To Live (TTL) period.
wait <1-60>: Specifies the time period to wait.
queries <1-10>: Specifies how many times the Switch
performs the traceroute function.
E
0
traceroute help
Provides more information about the specified command.
E
0
write memory [<index>]
Saves current configuration in volatile memory to the
configuration file the Switch is currently using or the specified
configuration file.
E
13
Table 151 Command Summary: Additional Configure Mode
COMMAND
DESCRIPTION
M
P
bcp-transparency
Enables Bridge Control Protocol (BCP) transparency on the
Switch.
C
13
default-management
Sets which traffic flow (in-band or out-of-band) the Switch
sends packets originating from itself (such as SNMP traps) or
packets with unknown source.
C
13
hostname <name>
Sets the Switch’s name for identification purposes.
name: 1-64 printable characters; spaces are allowed if you
put the string in double quotation marks (“).
C
13
install help
Displays command help information.
C
13
install slot <slot-list> type
<card-type>
Changes what type of card is in the slot without restarting the
system.
C
13
no install slot <slot>
Uninstalls the card in the slot.
C
13
mode zynos
Changes the CLI mode to the ZyNOS format.
C
13
no shutdown slot <slot-list>
Turns on the power to the slot.
C
13
shutdown slot <slot-list>
Turns off the power to the slot.
C
13
transceiver-ddm timer <1 -
4294967>
Sets the duration of the digital diagnostic monitoring (DDM)
timer.
This defines how often (in miliseconds) the Switch sends the
digital diagnostic monitoring (DDM) information via the
installed transceiver(s).
C
13
Table 150 Command Summary: Additional Enable Mode (continued)
COMMAND
DESCRIPTION
M
P
sysname# cable-diagnostics 7
port 7
cable diagnostics result
pairA: Ok
pairB: Ok