ZyXEL Communications ZyXEL Dimension ES-2024PWR User Manual
Page 252
Chapter 73 Additional Commands
Ethernet Switch CLI Reference Guide
252
boot image
<1|2>
The Switch supports dual firmware images, ras-0 and ras-1.
Run this command, where
specify which image is updated when firmware is loaded
using the web configurator and to specify which image is
loaded when the Switch starts up.
E
13
cable-diagnostics <port-list>
Perform a physical wire-pair test of the Ethernet connections
on the specified port(s).
Ok: The physical connection between the wire-pair is okay.
Open: There is no physical connection between the wire-pair.
E
13
ping <ip|host-name> [vlan <vlan-
id>] [size <0-1472>] [-t]
Sends Ping packets to the specified Ethernet device.
vlan-id: Specifies the VLAN ID to which the Ethernet
device belongs.
size <0-1472>: Specifies the size of the Ping packet.
-t: Sends Ping packets to the Ethernet device indefinitely.
Press [CTRL]+C to terminate the Ping process.
E
0
ping help
Provides more information about the specified command.
E
0
reload config [1|2]
Restarts the system (warm reboot) with the specified
configuration file.
1: config-1
2: config-2
E
13
reset slot <slot-list>
Restarts the card in the selected slot. The card restarts using
the last-saved configuration. Any unsaved changes are lost.
E
13
show al1arm-status
Displays alarm status.
E
0
show cpu-utilization
Displays the CPU utilization statistics on the Switch.
E
0
show hardware-monitor
This command is not available in all models.
Displays current hardware monitor information with the
specified temperature unit (Celsius C or Fahrenheit F).
E
0
show memory
Displays the memory utilization statistics on the Switch.
E
3
show power-source-status
Displays the status of each power module in the system.
E
0
show sfp <port-list>
Displays real-time SFP (Small Form Facter Pluggable)
transceiver operating parameters on specified SFP port(s).
The parameters include, for example, module temperature,
module voltage, transmitting and receiving power.
E
3
show interfaces transceiver
<port-list>
Displays real-time SFP (Small Form Facter Pluggable)
transceiver information and operating parameters on
specified SFP port(s). The parameters include, for example,
module temperature, module voltage, transmitting and
receiving power.
E
3
show slot
Displays general status information about each slot.
E
13
show slot config
Displays what type of card is installed in each slot and its
current operational status.
E
13
show slot config <slot-list>
Displays detailed information about the specified slots.
E
13
show system-information
Displays general system information.
E
0
show version [flash]
Display the version of the currently running firmware on the
Switch. Optionally, display the version of the currently
installed firmware on the flash memory.
E
0
test interface port-channel
<port-list>
Performs an internal loopback test on the specified ports. The
test returns Passed! or Failed!.
E
13
Table 150 Command Summary: Additional Enable Mode (continued)
COMMAND
DESCRIPTION
M
P