ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 111)

Ethernet Switch CLI Reference Guide
111
C
H A P T E R
24
IGMP Filtering Commands
Use these commands to configure IGMP filters and IGMP filtering on the Switch.
24.1 Command Summary
The following section lists the commands for this feature.
Table 65 igmp-filtering Command Summary
COMMAND DESCRIPTION M P
show igmp-filtering profile Displays IGMP filtering profile settings. E 3
igmp-filtering Enables IGMP filtering on the Switch. Ports can only join
multicast groups specified in their IGMP filtering profile.
C 13
no igmp-filtering Disables IGMP filtering on the Switch. C 13
igmp-filtering profile <name>
start-address <ip> end-address
<ip> Sets the range of multicast address(es) in a profile.
name: 1-32 alphanumeric characters C 13
no igmp-filtering profile <name> Removes the specified IGMP filtering profile. You cannot
delete an IGMP filtering profile that is assigned to any ports.
C 13
no igmp-filtering profile <name>
start-address <ip> end-address
<ip> Clears the specified rule of the specified IGMP filtering profile. C 13
show interfaces config <port-
list> igmp-filtering Displays IGMP filtering settings. E 3
interface port-channel <port-
list> Enters config-interface mode for the specified port(s). C 13
igmp-filtering profile
<name> Assigns the specified IGMP filtering profile to the port(s). If
IGMP filtering is enabled on the Switch, the port(s) can only
join the multicast groups in the specified profile.
C 13
no igmp-filtering profile Prohibits the port(s) from joining any multicast groups if IGMP
filtering is enabled on the Switch.
C 13