Trunk commands, 1 command summary, Trunk commands (223) – ZyXEL Communications ZyXEL Dimension ES-2024PWR User Manual
Page 223
Ethernet Switch CLI Reference Guide
223
C
H A P T E R
64
Trunk Commands
Use these commands to logically aggregate physical links to form one logical, higher-
bandwidth link. The Switch adheres to the IEEE 802.3ad standard for static and dynamic
(Link Aggregate Control Protocol, LACP) port trunking.
"
Different models support different numbers of trunks (T1, T2, ...). This chapter
uses a model that supports six trunks (from T1 to T6).
64.1 Command Summary
The following section lists the commands for this feature.
Table 133 trunk Command Summary
COMMAND
DESCRIPTION
M
P
show trunk
Displays link aggregation information.
E
3
trunk
Activates a trunk group.
C
13
no trunk
Disables the specified trunk group.
C
13
trunk
criteria
ip>
Sets the traffic distribution type used for the specified trunk
group.
C
13
no trunk
criteria
Returns the traffic distribution type used for the specified
trunk group to the default (src-dst-mac).
C
13
trunk
interface <port-list>
Adds a port(s) to the specified trunk group.
C
13
no trunk
interface <port-list>
Removes ports from the specified trunk group.
C
13
trunk
Enables LACP for a trunk group.
C
13
no trunk
lacp
Disables LACP in the specified trunk group.
C
13
trunk interface <port-list>
timeout <lacp-timeout>
Defines LACP timeout period (in seconds) for the specified
port(s).
lacp-timeout: 1 or 30
C
13