ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 113)

Ethernet Switch CLI Reference Guide
113
C
H A P T E R
25
Interface Commands
Use these commands to configure basic port settings.
25.1 Command Summary
The following section lists the commands for this feature.
Table 66 interface Command Summary
COMMAND DESCRIPTION M P
clear interface <port-num> Clears all statistics for the specified port. E 13
show interfaces <port-list> Displays the current interface status for the specified
port(s).
E 3
no interface <port-num> Resets the port counters for the specified port(s). E 13
show interfaces config <port-list> Displays current interface configuration for the specified
port(s).
E 3
interface port-channel <port-list> Enters config-interface mode for the specified port(s). C 13
inactive Disables the specified port(s) on the Switch. C 13
no inactive Enables the port(s) on the Switch. C 13
name <port-name-string> Sets a name for the port(s).
port-name-string: up to 64 English keyboard
characters
C 13
speed-duplex full|100-half|100-full|1000-
full> Sets the duplex mode ( half or full ) and speed ( 10 ,
100 or 1000 Mbps) of the connection on the interface.
Select auto (auto-negotiation) to let the specified
port(s) negotiate with a peer to obtain the connection
speed and duplex mode.
C 13
flow-control Enables interface flow control. Flow control regulates
transmissions to match the bandwidth of the receiving
port.
C 13
no flow-control Disables flow control on the port(s). C 13
qos priority <0-7> Sets the quality of service priority for an interface. C 13
frame-type
Choose to accept both tagged and untagged incoming
frames (all), just tagged incoming frames (tagged) or
just untagged incoming frames on a port (untagged).
Note: Not all switch models support accepting
untagged frames on a port.
C 13
pvid <1-4094> The default PVID is VLAN 1 for all ports. Sets a PVID in
the range 1 to 4094 for the specified interface.
C 13