ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 165)

Chapter 43 OSPF Commands
Ethernet Switch CLI Reference Guide
165
area <area-id> virtual-link <router-ID>
authentication-same-as-area Sets the virtual link to use the same
authentication method as the area.
C 13
no area <area-id> virtual-link <router-
id> authentication-same-as-area Resets the authentication settings on this
virtual area.
C 13
area <area-id> virtual-link <router-id>
message-digest-key <keyid> md5 <key> Enables MD5 authentication and sets the
key ID and key for the virtual link in the
area.
C 13
no area <area-id> virtual-link <router-
id> message-digest-key Resets the authentication settings on this
virtual link.
C 13
area <area-id> virtual-link <router-id>
name <name> Sets a descriptive name for the virtual link
for identification purposes.
C 13
exit Leaves the router OSPF configuration
mode.
C 13
network <ip-addr/bits> area <area-id> Creates an OSPF area. C 13
no network <ip-addr/bits> Deletes the OSPF network. C 13
redistribute rip metric-type <1|2> metric
<0-16777214> Sets the Switch to learn RIP routing
information which will use the specified
metric information.
C 13
redistribute rip Sets the Switch to redistribute RIP routing
information.
Route redistribution allows your Switch to
import and translate external routes
learned through other routing protocols
(RIP and Static) into the OSPF network
transparently.
C 13
no redistribute rip Sets the Switch not to learn RIP routing
information.
C 13
redistribute static metric-type <1|2>
metric <0-16777214> Sets the Switch to learn static routing
information which will use the specified
metric information.
C 13
redistribute static Sets the switch to redistribute static routing
information.
Route redistribution allows your Switch to
import and translate external routes
learned through other routing protocols
(RIP and Static) into the OSPF network
transparently.
C 13
no redistribute static Sets the Switch not to learn static routing
information.
C 13
passive-iface <ip-addr/bits> Sets the interface to be passive. A passive
interface does not send or receive OSPF
traffic.
C 13
no passive-iface <ip-addr/bits> Sets the interface to not be passive. C 13
summary-address <ip-address> <mask> Sets a summary address which is a
network IP address used to cover more
than one network routing entry in order to
reduce the routing table size.
C 13
no summary-address <ip-address> <mask> Removes a summary address. C 13
Table 97 OSPF Command Summary (continued)
COMMAND DESCRIPTION M P