ZyXEL Communications NBG-419N - Manual (Page 93)

Chapter 10 Tutorials
NBG-419N User’s Guide
93
10.4 Enabling and Configuring Wireless Security
(No WPS)
This example shows you how to configure wireless security settings with the
following parameters on your NBG-419N.
Follow the steps below to configure the wireless settings on your NBG-419N.
The instructions require that your hardware is connected (see the Quick Start
Guide) and you are logged into the Web Configurator through your LAN connection
(see
Section 3.2 on page 37 ).
1 Open the Wireless LAN > General screen in the AP’s Web Configurator.
2 Make sure the Enable Wireless LAN check box is selected.
3 Enter SSID_Example3 as the SSID and select a channel.
4 Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in
the Pre-Shared Key field. Click Apply.
Figure 60 Tutorial: Network > Wireless LAN > General
SSID SSID_Example3
Channel 6
Security WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)