ZyXEL Communications NBG-419N - Manual (Page 60)

Chapter 6 Easy Mode
NBG-419N User’s Guide
60
6.6.7 WPS
Use this screen to add a wireless station to the network using WPS. Click WPS in
the Wireless Security to open the following screen.
Figure 37 Wireless Security: WPS
The following table describes the labels in this screen.
Table 22 Wireless Security: WPS
LABEL DESCRIPTION
Wireless
Security Click this to go back to the Wireless Security screen.
WPS Create a secure wireless network simply by pressing a button .
The NBG-419N scans for a WPS-enabled device within the range and
performs wireless security information synchronization.
Note: After you click the WPS button on this screen, you have to
press a similar button in the wireless station utility within 2
minutes. To add the second wireless station, you have to
press these buttons on both device and the wireless station
again after the first 2 minutes.
Register Create a secure wireless network simply by entering a wireless
client's PIN (Personal Identification Number) in the NBG-419N’s
interface and pushing this button.
Type the same PIN number generated in the wireless station’s utility.
Then click Register to associate to each other and perform the wireless
security information synchronization.
Exit Click Exit to close this screen.