ZyXEL Communications NBG-419N - Manual (Page 106)

Chapter 11 Wireless LAN
NBG-419N User’s Guide
106
In order to configure and enable WEP encryption, click Network > Wireless LAN
to display the General screen. Select Static WEP from the Security Mode list.
Figure 69 Network > Wireless LAN > General: Static WEP
The following table describes the wireless LAN security labels in this screen.
Table 38 Network > Wireless LAN > General: Static WEP
LABEL DESCRIPTION
Security
Mode Select Static WEP to enable data encryption.
PassPhrase Enter a Passphrase (up to 26 printable characters) and click Generate.
A passphrase functions like a password. In WEP security mode, it is further
converted by the NBG-419N into a complicated string that is referred to as
the “key”. This key is requested from all devices wishing to connect to a
wireless network.
WEP
Encryption Select 64-bit WEP or 128-bit WEP.
This dictates the length of the security key that the network is going to
use.