ZyXEL Communications NBG-419N - Manual (Page 220)

Chapter 31 Troubleshooting
NBG-419N User’s Guide
220
You will lose all of your changes when you push the RESET button.
To reset the NBG-419N,
1 Make sure the power LED is on.
2 Press the RESET button for longer than 1 second to restart/reboot the NBG-419N.
3 Press the RESET button for longer than five seconds to set the NBG-419N back to
its factory-default configurations.
If the NBG-419N restarts automatically, wait for the NBG-419N to finish
restarting, and log in to the Web Configurator. The password is “1234”.
If the NBG-419N does not restart automatically, disconnect and reconnect the
NBG-419N’s power. Then, follow the directions above again.
31.5 Wireless Router/AP Troubleshooting
I cannot access the NBG-419N or ping any computer from the WLAN (wireless
AP or router).
1 Make sure the wireless LAN is enabled on the NBG-419N
2 Make sure the wireless adapter on the wireless station is working properly.
3 Make sure the wireless adapter installed on your computer is IEEE 802.11
compatible and supports the same wireless standard as the NBG-419N.
4 Make sure your computer (with a wireless adapter installed) is within the
transmission range of the NBG-419N.
5 Check that both the NBG-419N and your wireless station are using the same
wireless and wireless security settings.
6 Make sure traffic between the WLAN and the LAN is not blocked by the firewall on
the NBG-419N.
7 Make sure you allow the NBG-419N to be remotely accessed through the WLAN
interface. Check your remote management settings.