ZyXEL Communications NBG-419N User Manual
Page 73
Chapter 8 Access Point Mode
NBG-419N User’s Guide
73
8.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1
Connect your computer to the LAN port of the NBG-419N.
2
The default IP address of the NBG-419N is “192.168.1.2”. In this case, your
computer must have an IP address in the range between “192.168.1.3” and
“192.168.1.254”.
3
Click Start > Run on your computer in Windows. Type “cmd” in the dialog box.
Enter “ipconfig” to show your computer’s IP address. If your computer’s IP
address is not in the correct range then see
for
information on changing your computer’s IP address.
4
After you’ve set your computer’s IP address, open a web browser such as Internet
Explorer and type “192.168.1.2” as the web address in your web browser.
Note: After clicking Login, the Easy mode appears. Refer to
for
the Easy mode screens. Change to Expert mode to see the screens described
in the sections following this.
8.3.3 Configuring your WLAN, Bandwidth Management and
Maintenance Settings
The configuration of wireless, bandwidth management and maintenance settings
in Access Point mode is the same as for Router Mode.
• See
for information on the configuring your wireless
network.
• See
for information on configuring your Bandwidth
Management screen.
• See
Maintenance and Troubleshooting (193)
for information on configuring your
Maintenance settings.