ZyXEL Communications NBG-419N - Manual (Page 69)

Chapter 7 Router Mode
NBG-419N User’s Guide
69
RIP Use this screen to enable RIPv1 or RIPv2, which are LAN
broadcast protocols.
Security
Firewall General Use this screen to activate/deactivate the firewall.
Services This screen shows a summary of the firewall rules, and
allows you to edit/add a firewall rule.
Content Filter Use this screen to block certain web features and sites
containing certain keywords in the URL.
Management
Bandwidth
Manageme
nt
General Use this screen to enable bandwidth management.
Advanced Use this screen to set the upstream bandwidth and edit a
bandwidth management rule.
Monitor Use this screen to view the amount of network
bandwidth that applications running in the network
are using.
Remote
Manageme
nt
WWW Use this screen to be able to access the NBG-419N
from the LAN, WAN or both.
UPnP General Use this screen to enable UPnP on the NBG-419N.
MAINTENANCE
General Use this screen to view and change administrative settings
such as system and domain names.
Password Password
Setup Use this screen to change the password of your NBG-
419N.
Time Time
Setting Use this screen to change your NBG-419N’s time and date.
Remote
Manageme
nt
WWW Use this screen to configure through which interface(s)
and from which IP address(es) users can use HTTP to
manage the NBG-419N.
Firmware
Upgrade
Use this screen to upload firmware to your NBG-419N.
Backup/
Restore
Use this screen to backup and restore the configuration or
reset the factory defaults to your NBG-419N.
Reset/
Restart
Restart This screen allows you to reboot the NBG-419N without
turning the power off.
Sys OP
Mode
This screen allows you to select whether your device acts
as a Router or a Access Point.
Table 26 Navigation Panel: Router Mode
LINK TAB FUNCTION