ZyXEL Communications NBG-419N - Manual (Page 182)

Chapter 22 Remote Management
NBG-419N User’s Guide
182
22.3.1 Remote Management and NAT
When NAT is enabled:
• Use the NBG-419N’s WAN IP address when configuring from the WAN.
• Use the NBG-419N’s LAN IP address when configuring from the LAN.
22.3.2 System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The NBG-419N automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling. You can change the timeout
period in the System screen
22.4 WWW Screen
To change your NBG-419N’s remote management settings, click Management >
Remote Management > WWW.
Figure 111 Management > Remote Management > WWW
The following table describes the labels in this screen
Table 71 Management > Remote Management > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Server Access Select the interface(s) through which a computer may access the NBG-
419N using this service.
Secured Client
IP Address Select All to allow all computes to access the NBG-419N.
Otherwise, check Selected and specify the IP address of the computer
that can access the NBG-419N.