3 what you need to know, 1 setting your nbg-419n to wisp mode, 2 accessing the web configurator in wisp mode – ZyXEL Communications NBG-419N User Manual
Page 80
Chapter 9 WISP Mode
NBG-419N User’s Guide
80
9.3 What You Need to Know
With the exception of the LAN screen, the Monitor, Configuration and
Maintainance screens in WISP mode are similar to the ones in Router Mode. See
through
of this User’s Guide.
9.3.1 Setting your NBG-419N to WISP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for
instructions on how to do this.
2
To set your NBG-419N to AP Mode, go to Maintenance > Sys OP Mode >
General and select WISP Mode.
Figure 49 Changing to WISP mode
Note: You have to log in to the Web Configurator again when you change modes.As
soon as you do, your NBG-419N is already in WISP mode.
3
When you select WISP Mode, the following pop-up message window appears.
Figure 50 Pop up window for WISP mode
Click OK. The Web Configurator refreshes once the change to WISP mode is
successful.
9.3.2 Accessing the Web Configurator in WISP Mode
To login to Web Configurator in WISP mode, do the following: