Toshiba H1 SERIES TLCS-900 - Manual (Page 28)

TMP92CM22
2007-02-16 92CM22-26
c. STOP mode
When STOP mode is selected, all internal circuits stop, including the internal
oscillator pin status in STOP mode depends on the settings in the
SYSCR2 register. Table 3.3.5, Table 3.3.6 shows the state of
these pins in STOP mode.
After STOP mode has been released system clock output starts when the
warm-up time has elapsed, in order to allow oscillation to stabilize. Warm-up time
set by SYSCR2 register. See the sample warm-up times in Table
3.3.4.
Figure 3.3.8 illustrates the timing for release of the STOP mode halt state by an
interrupt.
Interrupt of
releasing halt
Data Data
STOP
mode
X1
A0 to A23
D0 to D15
RD
WR
Warm-up time
Figure 3.3.8 Timing Chart for STOP Mode Halt State Released by Interrupt
Table 3.3.4 Sample Warm-up Times after Rrelease of STOP Mode
at f OSCH
= 10 MHz
SYSCR2
01 (2
8
) 10 (2
14
) 11 (2
16
)
25.6 μs 1.638 ms 6.554 ms