Table 2−19. smart card terminals – Texas Instruments Dual/Single Socket CardBus and UntraMedia Controller PCI7621 User Manual
Page 55
2−29
Table 2−19. Smart Card Terminals
†
If any Smart Card terminal is unused, then the terminal may be left floating, except for SC_VCC_5V which must be
connected to 5 V.
TERMINAL
DESCRIPTION
I/O
INPUT
OUTPUT
PU/
POWER
EXTERNAL
NAME
NO.
DESCRIPTION
I/O
TYPE
INPUT
OUTPUT
PU/
PD
POWER
RAIL
EXTERNAL
PARTS
SC_CD
L02
Smart Card card detect. This input is asserted when Smart
Cards are inserted.
I
TTLI2
SW2
VCC
SC_CLK
K05
Smart Card clock. The controller drives a 3-MHz clock to the
Smart Card interface when enabled.
O
PCIO8
22 k
Ω
resistor to
GND
68 pF capacitor
to GND
SC_DATA
L01
Smart Card data input/output
I/O
PCII5
PCIO5
SW3
SC_OC
L03
Smart Card overcurrent. This input comes from the Smart
Card power switch.
I
LVCI1
PU2
5 V
SC_PWR_CTRL
L05
Smart Card power control for the Smart Card socket.
O
LVCO1
Power switch or
FET to turn on
power to FM
socket
SC_FCB
K02
Smart Card function code. The controller does not support
synchronous Smart Cards as specified in ISO/IEC 7816-10,
and this terminal is in a high-impedance state.
I
PCII5
PCIO5
SW3
SC_GPIO6
SC_GPIO5
SC_GPIO4
SC_GPIO3
SC_GPIO2
SC_GPIO1
SC_GPIO0
H03
J06
J01
J02
J03
J05
J07
Smart Card general-purpose I/O terminals. These signals
can be controlled by firmware and are used as control
signals for an external Smart Card interface chip or level
shifter.
I/O
TTLI2
TTLO2
SW2
5 V
SC_RFU
K01
Smart Card reserved. This terminal is in a high-impedance
state.
I
PCII5
PCIO5
SW3
5 V
SC_RST
K03
Smart Card This signal starts and stops the Smart Card
reset sequence. The controller asserts this reset when
requested by the host.
O
PCIO6
SC_VCC_5V
K07
Smart Card power terminal
PWR
1 k
Ω
resistor to
5 V
† These terminals are reserved for the PCI7421 and PCI7411 controllers.