Texas Instruments Dual/Single Socket CardBus and UntraMedia Controller PCI7621 - Manual (Page 289)

13−17
13.26 Smart Card Configuration 2 Register
BIOS or EEPROM configure system dependent Smart Card interface information through this register. Information
of this register can be read from the Smart Card configuration 2 alias in the Smart Card global control register set.
The software utilizes this information and adjusts the software and firmware behavior, if necessary.
See Table 13−16 for a complete description of the register contents. All bits in this register are reset by GRST only.
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Name Smart Card configuration 2
Type R R R R R R R R R R R R R R R R
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Name Smart Card configuration 2
Type RW RW RW RW RW RW RW RW RW RW RW RW RW RW RW RW
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Register: Smart Card Configuration 2
Offset: 54h
Type: Read-only, Read/Write (EEPROM, GRST only)
Default: 0000 0000h
Table 13−16. Smart Card Configuration 2 Register Description
BIT SIGNAL TYPE FUNCTION
31−16 RSVD R Reserved. Bits 31−16 return 0s when read.
15−8
PWRUP_DELAY_
PCMCIA
R
Power up delay for the PCMCIA socket. This register indicates how long the external power switch
takes to apply stable power to the PCMCIA socket in ms. Software must wait before starting
operation after power up. This field has no effect for the hardware.
7−0 RSVD R Reserved. Bits 7−0 return 0s when read.