Toshiba 6F3B0253 - Manual (Page 67)

6F3B0253
Basic Hardware and Function
65
5. Operating System Overview
The operation modes are switched by the mode control switch provided on the T1-16S
and the mode control commands issued from the programming tool.
The mode transition conditions are shown below.
n
Mode control switch is in R (RUN) side.
o
Mode control switch is in H (HALT) side.
p
Mode control switch is turned to H (HALT) side, or HALT command is issued from
the programming tool.
q
Mode control switch is turned to R (RUN) side, or RUN command is issued from
the programming tool.
r
Force RUN (RUN-F) command is issued from the programming tool.
s
HOLD command is issued from the programming tool.
t
HOLD Cancel command is issued from the programming tool.
u
Error Reset command is issued from the programming tool.
(dotted line) Error is detected by self-diagnosis.
The commands from the programming tool are available when the mode
control switch is in R (RUN) side.
(Power ON)
RUN
HALT
HOLD
RUN-F
ERROR
n
o
p
p
t
q s
r
s
t
p
u
NOTE