Roland RK-500 - Manual (Page 135)

134
Connecting Other Equipment
By connecting the VIMA to your audio equipment or external
speakers, you can play the VIMA’s sounds from your stereo
system’s speakers or from other external speakers, or record
your performance on an tape recorder or other recording
device.
To make connections, use an audio cable with 1/4” phone
plugs.
fig.audio1.eps
1. Minimize the volume of the VIMA and of the
speakers you are connecting.
2. Switch off power to the VIMA and the
speakers you are connecting.
3. Make connections using separately available
audio cables.
4. Switch on the VIMA’s power.
5. Switch on power to the connected speakers.
6. Adjust the volume of the VIMA and the
connected speakers.
Play the VIMA’s keyboard, and sound will be produced
from the connected speakers (or stereo set).
Turning the Power Off
1. Minimize the volume of the VIMA and of the
connected speakers.
2. Switch off power to your speakers.
3. Switch off power to the VIMA.
Connecting Audio Equipment
* If you use a connection cable that has a built-in
resistor, the volume of the device connected to the
input jack may be low. Please use connection cables
that do not contain a resistor.
921
* Before connecting the VIMA to other devices, you
must turn down the volume of all devices and turn off
their power to prevent malfunctions or speaker
damage.
Playing the VIMA through Connected Speakers
AUDIO OUTPUT
jacks
AUDIO OUTPUT
jacks
Speaker etc.
Input (Line In)
RK-500-e.book 134 ページ ２００６年８月１１日 金曜日 午後４時２９分