NEC Express 5800/230Eh - Manual (Page 97)

Configuring Your Server 4-33
Menu Tree
Setting list
+: Selection/execution parameter ‘: Setting parameter. •: Information display
>: Can be set (modified) after creation of logical drive
Menu Description
+Configure Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)
+New Configuration Set new configuration
+View/Add Configuration Additional setting / viewing configuration
+Clear Configuration Clear configuration
+Select Boot Drive Chose Bootable Logical Drive
+Initialize Initialize logical drive
+Objects Various settings
+Adapter Set disk array controller
+Sel. Adapter Clear configuration
‘ Rebuild Rate 30
‘ Chk Const Rate 30
‘ FGI Rate 30
‘ BGI Rate 30
‘ Disk WC Display default value (setting not required)
‘ Read Ahead On
‘ Bios State Enable
‘ Stop on Error No
‘ Fast Init Enable
‘ Auto Rebuild On
‘ Auto Resume Enable
‘ Disk Coercion 1GB
‘ Factory Default Default setting
+Logical Drive Logical drive operation
+Logical Drives Select logical drive (when multiple logical drives exist)
+Initialize Initialize logical drive
+Check Consistency Check logical drive redundancy
+View/Update Parameters Display logical drive information
• RAID Display RAID level
• SIZE Display logical drive capacity
• Stripe SIZE Display stripe size
• #Stripes Display the number of hard disk drives in logical drive
• State Display logical drive status
• Spans Display setting of span
• Disk WC Display setting of write cache
• Read Ahead Display setting of read ahead
+Physical Drive Physical drive operation
+Physical Drive Selection Menu Select physical drive
+Make HotSpare Set as hot-spare disk for auto rebuilding
+Force Online Make a disk online
+Force Offline Make a disk offline
+Drive Properties Display hard disk drive information
• Device Type Hard disk drive type
• Capacity Hard disk drive capacity
• Product ID Hard disk drive model
• Revision No. Hard disk drive revision
+Rebuild Perform rebuilding
+Check Consistency Perform logical drive redundancy check