NEC Express 5800/230Eh - Manual (Page 150)

6-10 Installing and Using Utilities
Starting
The following two methods are available to start the server.
„ Running NEC EXPRESSBUILDER from the management PC via LAN
„ Running NEC EXPRESSBUILDER from the management PC via direct connection
(COM B)
For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see
"NEC DianaScope".
IMPORTANT:
„ Do not change the boot device order in BOOT menu in BIOS
SETUP. NEC EXPRESSBUILDER cannot be used if the DVD-
ROM drive is not the first device to launch the system.
„ To use the remote console feature, a floppy disk containing a
configuration information file must be inserted in the floppy disk
drive. You can create a configuration information file by using
System Management feature in the Tools menu or by NEC
DianaScope Configuration menu. The configuration information
file must be named as "CSL_LESS.CFG" and stored in the root
directory of the floppy disk.
NOTE: The following items of BIOS setup information will be set as
shown below.
„ LAN Controller: [Enabled]
„ Serial Port A: [Enabled]
Base I/O Address: [3F8]
Interrupt: [IRQ 4]
„ Serial Port B: [Enabled]
Base I/O Address: [2F8]
Interrupt: [IRQ 3]
„ BIOS Redirection Port: [Serial B]
„ Baud Rate: [19.2K]
„
Flow Control: [CTS/RTS]
„ Console Type: [PC ANSI]