NEC Express 5800/230Eh - Manual (Page 74)

4-10 Configuring Your Server
The items which can be set on the Main menu screen and their functions are described below.
Option Parameter Description Your Setting
System Time HH:MM:SS Set the system time.
System Date MM/DD/YYYY Set the system date.
Hard Disk Pre-Delay [Disabled]
3 seconds
6 seconds
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds Allows slower spin-up drives to
come ready.
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave – Shows the information on the
device connected to each
channel on the submenu. If only
one hard disk drive is connected
to serial ATA channel, the
information is displayed on area
for Primary IDE.
The settings of some items may
be changed. However, leave the
items as they are at the
shipment.
Processor Settings – Shows the processor settings
submenu. See the next page.
Language [English (US)]
Français
Deutsch
Español
Italiano Select which language BIOS
displays.
[ ]: Factory-set
IMPORTANT: Check and adjust the system clock before the
operation if any of the following conditions is applicable.
„ After carriage of device
„
After storage of device
„ After the device is entered into the pause state under the
environmental condition enduring device operation (temperature:
10°C - 35°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the
system clock is installed in a system requiring high time precision, it is
recommended to use a time server (NTP server).
If the system clock is remarkably delayed or advanced as the passage of
time in spite of adjustment, contact your service representative for
maintenance.