NEC Express 5800/230Eh - Manual (Page 50)

2-22 General Description
When you fail to eject:
When you fail to eject the tray with the Open/Close button and take out the disc from the server,
follow the procedure below.
1. Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2. Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the front
of the DVD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
„ Do not use a toothpick or plastic stick that is easy to break.
„ If the above procedure does not let you take out the DVD/CD-ROM,
contact your service representative.
3. Hold the tray and pull it out.
4. Take out the disc.
5. Push the tray back into position.
Emergency hole