NEC Express 5800/230Eh - Manual (Page 107)

Configuring Your Server 4-43
Others
1. Clear Configuration
Clears configuration information. Select "Configure" → "Clear Configuration" from the
TOP menu. Executing "Clear Configuration" clears all configuration information on the
disk array controller and hard disk drives. The configuration information on all channels
of the disk array controller is also cleared.
NOTES:
„
When configuration information on the disk array controller and
that on the hard disk drive do not match (excluding at replacement
of faulty disk array controller), configuration mail fail if you select
the configuration information on the disk array controller. In this
case, execute "Clear Configuration" to create configuration again.
„ LSI Logic Software RAID Setup Utility cannot delete each logical
drive. Use MegaRAID Storage Manager instead.
2. Force Online
Puts a hard disk drive being in the FAIL status online.
Select "Objects" → "Physical Drive" → (select hard disk drive) → "Force Online" from
the TOP menu.
3. Rebuild Rate
Sets the Rebuild Rate.
Select "Objects" → "Adapter" → "Sel. Adapter" → "Rebuild Rate" from the TOP menu.
Available value is between 0% and 100%. Default value (recommended) is 30%.
4. Hard disk drive information
Checks hard disk drive information.
Select "Objects" → "Physical Drive" → (select hard disk drive) → "Drive Properties"
from the TOP menu.