Starting setup utility – NEC Express 5800/230Eh User Manual

Page 67

Text mode
Original mode

Configuring Your Server 4-3

Starting SETUP Utility

A few seconds after powering on, the following message appears at bottom left on the screen.
If NEC logo appears instead, press Esc.

Press to enter SETUP or Press to boot from Network

Press F2 to start the BIOS Setup utility and display its Main menu.

If you have previously set a password with the BIOS Setup utility, the password entry screen
appears. Enter the password.

Enter password:[ ]

Up to three password entries will be accepted. If you fail to enter the password correctly for three
consecutive times, the server halts. (You can no longer proceed.) Power off the server.

NOTE:

The server is provided with two levels of password:

Supervisor and User. With the Supervisor password, you can view and
change all system parameters. With the User password, system
parameters available for viewing and changing are limited.