NEC Express 5800/230Eh - Manual (Page 181)

Troubleshooting 8-5
1000/100/10 Lamp
The 1000/100/10 lamp indicates whether each of the network ports normally equipped with the
server is operated through the 1000BASE-T, 100BASE-TX or 10BASE-T network interface. If the
lamp is lit orange, the network port is operated through 1000BASE-T. If the lamp is lit green, the
network port is operated through 100BASE-TX. If the lamp is off, the network port is operated
through 10BASE-T.
100/10 Lamp
The 100/10 indicates whether the management LAN port is operated through the 100BASE-TX or
10BASE-T network interface. If the lamp is lit green, the network port is operated through
100BASE-TX. If the lamp is off, the network port is operated through 10BASE-T.
Hard Disk Drive Lamp
The optional hot-swap SCSI hard disk drive bay can contain four 1-inch height hard disk drives.
Each hard disk drive has a DISK lamp on its front panel.
The DISK lamp indicates the drive status as follows.
„ Lighting green
The hard disk drive is installed and powered on.
„ Blinking green
Indicates that the hard disk drive is accessed.
„
Lighting amber
Indicates that the installed hard disk drive is defected.
NOTE: While hard disk drives are in the disk array configuration
(RAID1 or RAID5), a single failed hard disk drive does not affect the
operation of the server. However, it is recommended to replace the
failed hard disk drive and auto-rebuild (reconfigure) the hard disk
drives as soon as possible. (You can hot-swap such a failed hard disk
drive.)
DISK lamp