NEC Express 5800/230Eh - Manual (Page 124)

5-12 Installing the Operating System with Express Setup
NOTE: If you press F9 in [Role of Computer], the installation will be
done using the default values of Express Setup for the subsequent
settings automatically. (Only when the [OK] is displayed in the lower
right of the screen).
11. Copy the modules for the optional mass storage driver.
If you want to install the optional mass storage driver, insert the floppy disk attached to
mass storage driver into the floppy disk drive and follow the message to operate the
installation.
NOTE: You can use this function only when the floppy disk drive is
attached to the system.
12. Remove the NEC EXPRESSBUILDER CD-ROM from the DVD-ROM drive according
to the message.
If you proceed the setup by using setup parameter file, remove the floppy disk from the
floppy disk drive.
Insert Windows Server 2003 CD-ROM into the DVD-ROM drive.
[Agree Software License Agreement] screen appears.
13. Read the agreement carefully and click [I agree.] or press F8 if you do agree. If you do
not agree, click [I disagree] or press F3.
IMPORTANT:
„ If you do not agree to this agreement, the setup terminates and
Windows Server 2003 will not be installed.
„
If "NetWare Gateway (and Client) Service" is specified to install,
the window to specify the details of "NetWare Gateway (and
Client) Service" pops up on the first logon. Specify the appropriate
value.
14. If you selected [Yes] on [Apply Service Pack] at Basic Information, follow the procedure
below.
1) Follow the message to take Windows Server 2003 CD-ROM out of the DVD-ROM
drive.
2) Follow the message to insert Windows Server 2003 Service Pack 1 or later into the
DVD-ROM drive.
Windows Server 2003 and the specified application will be installed automatically and
logon to the system. Install and configure the device drivers.