Planet Technology SGSD-1022 - Manual (Page 641)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
641
5.25 Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to query for any attached hosts that want to receive a specific
multicast service. It identifies the ports containing hosts requesting a service and sends data out to those ports only. It then
propagates the service request up to any neighboring multicast switch/router to ensure that it will continue to receive the
multicast service.
Command Groups Function
IGMP Snooping Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, displays current snooping and query settings,
and displays the multicast service and group members
IGMP Query Configures IGMP query parameters for multicast filtering at Layer 2
Static Multicast Routing Configures static multicast router ports
IGMP Filtering and Throttling Configures IGMP filtering and throttling
Multicast VLAN Registration Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving security
and data isolation for normal traffic
Table 5-84 Multicast Filtering Commands
5.25.1 IGMP Snooping Commands
This section describes commands used to configure IGMP snooping on the switch.
Command Function Mode
ip igmp snooping Enables IGMP snooping GC
ip igmp snooping vlan static Adds an interface as a member of a multicast group GC
ip igmp snooping version Configures the IGMP version for snooping GC
ip igmp snoopingleave-proxy Enables IGMP leave proxy on the switch GC
ip igmp
snoopingimmediateleave
Immediately deletes a member port of a multicast service if a
leave packet is received at that port and immediate-leave is
enabled for the parent VLAN
IC
show ip igmp snooping Shows the IGMP snooping and query configuration PE
show mac-address-table
multicast
Shows the IGMP snooping MAC multicast list PE
Table 5-85 IGMP Snooping Commands
ip igmp snooping
This command enables IGMP snooping on this switch. Use the no form to disable it.
Syntax