Planet Technology SGSD-1022 - Manual (Page 379)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
379
Command Mode
Global Configuration
Command Usage
A colon (:) is required after the specified unit number and file type.
If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir
whichboot
5.6 Line Commands
You can access the onboard configuration program by attaching a VT100 compatible device to the server’s serial port. These
commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command Function Mode
line Identifies a specific line for configuration and starts the
lineconfiguration mode
GC
login Enables password checking at login LC
password Specifies a password on a line LC
timeout login response Sets the interval that the system waits for a user to log into the
CLI
LC
exec-timeout Sets the interval that the command interpreter waits until
userinput is detected
LC
password-thresh Sets the password intrusion threshold, which limits the number
of failed logon attempts
LC
silent-time* Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attemptsexceeds the threshold set by the password-thresh
command
LC
databits* Sets the number of data bits per character that are interpreted
and generated by hardware
LC
parity* Defines the generation of a parity bit LC