Planet Technology SGSD-1022 - Manual (Page 386)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
386
Console(config-line)#
speed
This command sets the terminal line’s baud rate. This command sets both the transmit (to terminal) and receive (from terminal)
speeds. Use the no form to restore the default setting.
Syntax
speed bps no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400 bps)
Default Setting
9600
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial port. Some baud rates available on devices
connected to the port might not be supported. The system indicates if the speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 19200
Console(config-line)#
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default setting.
Syntax
stopbits {1 | 2}
1 - One stop bit
2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#