Planet Technology SGSD-1022 - Manual (Page 445)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
445
5.12.6 Web Server Commands
This section describes commands used to configure web browser management access to the Managed Switch.
Command Function Mode
ip http port Specifies the port to be used by the web browser interface GC
ip http server Allows the switch to be monitored or configured from a browser GC
ip http secure-server Enables HTTPS for encrypted communications GC
ip http secure-port Specifies the UDP port number for HTTPS GC
Table 5-33 Web Server Commands
ip http port
This command specifies the TCP port number used by the web browser interface. Use the no form to use the default port.
Syntax
ip http port port-number no ip http port
port-number -The TCP port to be used by the browser interface. (Range: 1-65535)
Default Setting
80
Command Mode
Global Configuration
Example
Console(config)# ip http port 769
Console(config)#
Related Commands
ip http server
ip http server
This command allows this device to be monitored or configured from a browser. Use the no form to disable this function.
Syntax
[no] ip http server