Planet Technology SGSD-1022 - Manual (Page 408)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
408
Example
Console#show cluster candidates
Cluster Candidates:
Role Mac Description
ACTIVE MEMBER 00-30-4f-23-49-c0 24/48 L2/L4 IPV4/IPV6 GE Switch
CANDIDATE 00-40-4f-0b-47-a0 24/48 L2/L4 IPV4/IPV6 GE Switch
Console#
5.11 SNMP Commands
Controls access to this switch from management stations using the Simple Network Management Protocol (SNMP), as well as
the error types sent to trap managers.
SNMP Version 3 also provides security features that cover message integrity, authentication, and encryption; as well as
controlling user access to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then assign SNMP users to these groups, along with their
specific authentication and privacy passwords.
Command Function Mode
snmp-server Enables the SNMPv3 server GC
show snmp Displays the status of SNMP communications NE, PE
snmp-server community Sets up the community access string to permit access to SNMP
commands
GC
snmp-server contact Sets the system contact string GC
snmp-server location Sets the system location string GC
snmp-server host Specifies the recipient of an SNMP notification operation GC
snmp-server enable traps Enables the device to send SNMP traps (i.e.,
SNMPnotifications)
GC
snmp-server engine-id Sets the SNMPv3 engine ID GC
show snmp engine-id Shows the SNMPv3 engine ID PE
snmp-server view Adds an SNMPv3 view GC
show snmp view Shows the SNMPv3 views PE
snmp-server group Adds an SNMPv3 group, mapping users to views GC
show snmp group Shows the SNMPv3 groups PE
snmp-server user Adds a user to an SNMPv3 group GC
show snmp user Shows the SNMPv3 users PE
Table 5-21 SNMP Command