Planet Technology SGSD-1022 - Manual (Page 504)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
504
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current interface. (The CoS value determines the output
queue for packets matching an ACL rule.)
Syntax
show map access-list ip [interface] interface
• ethernet unit/port
-unit - This is device 1.
-port - Port number.
Command Mode
Privileged Exec
Example
Console# show map access-list ip
Access-list to COS of Eth 1/4
Access-list ALS1 cos 0
Console#
Related Commands
map access-list ip
5.14.2 MAC ACLs
The commands in this section configure ACLs based on hardware addresses, packet format, and Ethernet type. To configure
MAC ACLs, first create an access list containing the required permit or deny rules, and then bind the access list to one or more
ports
Command Function Mode
access-list mac Creates a MAC ACL and enters configuration mode GC
permit, deny Filters packets matching a specified source and destination
address, packet format, and Ethernet type
MAC-ACL
show mac access-list Displays the rules for configured MAC ACLs PE
mac access-group Adds a port to a MAC ACL IC
show mac access-group Shows port assignments for MAC ACLs PE
map access-list mac Sets the CoS value and corresponding output queue for packets
matching an ACL rule
IC