Planet Technology SGSD-1022 - Manual (Page 133)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
133
4.5.4 Trunk Membership
When configuring static trunks, you may not be able to link switches of different types, depending on the manufacturer's
implementation. However, note that the static trunks on this switch are Cisco EtherChannel compatible.
To avoid creating a loop in the network, be sure you add a static trunk via the configuration interface before connecting the ports,
and also disconnect the ports before removing a static trunk via the configuration interface.
Figure 4-5-4
For additional information, see Configuring Trunks.
Command Sequence - To configure a static trunk:
„ Enter a trunk ID of 1-5 in the Trunk field,
„ Select any of the Managed Switch ports from the scroll-down port list
„ Click Add.
„ After you have completed adding ports to the member list, click Apply.