Philips V24CT - Manual (Page 237)

Admitting a Patient
Admit/Discharge/End Case 7-9
Admit/Dis
c
har
g
e
/E
n
d
Case
Discharging
a Patient/
Ending a
Case Patient data for the current patient can be erased in the Patient
Information Task Window under
-->
(ICU configuration sets) or the End Case Task Window under
--> (OR configuration sets).
in ICU Configuration Sets erases the entire patient database. You must
press
for the discharge to take effect. The system returns to the
Admit Patient Task Window. in OR Configuration Sets also
erases the entire database. Additionally, the monitor resets all settings to
the user defaults and then returns to Monitor Standby. You must press
for the discharge to take effect. If configured, a scheduled
report is printed prior to ending the case.
Note— In ICU configuration not all settings are automatically reset to user
defaults. To do this manually press -->
--> . Do not change the selection and then press
.
If the monitor is connected to a Philips Documentation Center and
arrhythmia is assigned, arrhythmia must be unassigned under
. If the monitor is connected to a Philips central
station, discharge must be performed at central as well. The discharge
procedure is not complete until the patient's information is erased from
all parts of the system and the system is available for a new patient.
During a transfer to or from the M1235A Data Transfer Module, the
Discharge Patient and End Case Task Windows are not available.
Procedures Discharge Patient
Pts Refernce
Procedures End Case
Pts Refernce
Discharge Patient
Pts Refernce
Confirm
End Case
Pts Refernce
Confirm
Monitor Setup Adult/Pedi/Neo
Pts Refernce Change ConfSet
Pts Refernce Confirm
Arrhyth Functns
Pts Refernce