Philips V24CT - Manual (Page 342)

Controls and Connectors
11-26 Monitor Installation and Patient Safety
M
onitor
Ins
ta
lla
ti
on
a
nd Pa
ti
e
n
t Sa
fe
ty
2. V AMP; this is the vertical amplitude control used to adjust the
height of the displayed video.
3. V SHIFT; this is the vertical shift control used to adjust the vertical
position of the displayed video.
4. H AMP; this is the horizontal amplitude control used to adjust the
width of the displayed video.
5. EAST WEST; this control is used to adjust the pin-cushion effect of
the displayed video.
Connectors of
the M1092A,
M1094A and
M1094B
Displays
1. There are two fuse holders for the line protection fuses. The fuses
depend on the type of monitor and the power supply as
summarized below:
2. Local Power Connector; a 3-pin connector is used to input the
local line voltage.
3. System Power Connector; a 15-pin “D” type connector is used to
output 60V DC (100W max) to a similar connector on the DC/DC
converter in the rear of the computer module.
4. Video In Connector; a 9-pin “D” type connector is used to input the
video signal to be displayed from the display controller in the
computer module (DSPC for monochrome or CDSPC-Video for
color).
5. Video Out Connector; a 9-pin “D” type connector is used to output
the video signal to be displayed on a duplicate display.
200-240V M1094A color monitor 2.5A 250V
200-240V M1094B color monitor 3.15A 250V
200-240V monochrome monitor 2A 250V
100-120V color or monochrome monitor 4A 125V
(Slow-Blow)