Philips V24CT - Manual (Page 47)

Operating Levels
The CMS and V24 and V26 Patient Monitors 1-25
The
CM
S
a
n
d
V
2
4
a
nd
V
2
6
Pa
ti
e
n
t M
o
n
it
o
rs
Getting into
the
Operating
Levels Before you can start to make adjustments or changes to the parameters or
perform a procedure, you need to know how to get into the operating
levels and how to navigate through the selections. Follow the procedures
below to get into the Selection and Task Windows.
Selection Window
1. Press the blue-labeled hardkey for the function you require.
2. When you get into a Selection Window, the bottom line is always
active. Select the line with the parameter or function you require, by
pressing the same hard key again that got you into the selection
window, or use the arrow keys if they are illuminated.
3. Press either the softkey corresponding to the parameter or function
you require or . This gets you into the Task Window.
For example, to get into the Noninvasive Blood Pressure (NBP) Task
Window:
1. Press the hardkey
2. If it is not already active, select the line containing NBP by pressing
again.
3. Press the softkey to get into the Noninvasive Blood Pressure
Task Window.
Task Window
There are two ways to get into a parameter Task Window, either:
via the Selection Window,
or
by pressing the Setup key on the parameter module which gets you
directly into the Task Window.
Getting into other Task Windows for functions like Other Patients or
Monitor Setup is only possible via the Selection Window. In the Task
Window there are separate keys. The selections that are currently active
for the parameter or function you have chosen are indicated by yellow
labeling. In addition the selected keys appear to be “pushed in” on the
screen.
Confirm
Module Setup
Module Setup
NBP
Pts Refernce