Philips V24CT - Manual (Page 339)

Controls and Connectors
Monitor Installation and Patient Safety 11-23
M
onitor
Ins
ta
lla
ti
on
a
nd Pa
ti
e
n
t Sa
fe
ty
(or receive inputs from the Ohmeda 7800/7810 Ventilator or the
Anesthetic Gas Module).
Warning Warning
Make sure all devices connected to the RS232 connectors are
isolated. Consult your biomedical engineer, who will verify this for
you.
8. HDLC Connector; this is used to connect to a STRIP recorder (such
as the Philips M1117A).
9. Video Out Connector (CDSPC-Video or DSPC); this is a connector
used to output information to be displayed on the display module.
10. PS ON/OFF connector (DSPC_FLAT); this is left open.
11. Video Out Connector (Flatscreen); this is a connector used to
output information to be displayed on the Flatscreen Display
Module and also to output 60V DC to the Flatscreen Display Module.
The Rear
Panel of the
Display
Modules The system can have one of the following displays:
• the M1092A Monochrome display
• the M1094A Color display
• the M1094B Color display
• the M1095A Flatscreen Color display
The rear panel of each display module is shown below. The back of the
display module should only be removed by qualified service personnel