Philips V24CT - Manual (Page 352)

Controls and Connectors
11-36 Monitor Installation and Patient Safety
M
onitor
Ins
ta
lla
ti
on
a
nd Pa
ti
e
n
t Sa
fe
ty
Assembling
the V24 and
V26 The monitors consist of two individual parts.
1. One of two types of Display Modules, depending on the particular
model monitor you have— either:
a. A monochrome display with control panel supporting the
V24, or
b. A color flat panel display with control panel supporting the
V24C, V24CT, V26C and V26CT
2. The Rack with Parameter Modules
To assemble the display module and parameter rack:
• Connect the parameter module rack with the front end cable to
the connector on the left side of the display module.
• You now have an electrical connection from the rack to the
display module and will see monitoring displays.
Lifting the Display Module
The V24, V24C and V26C display module weighs 11.3 lbs (5.1 kg). The
V24CT and V26CT display module weight 14.8 lbs (6.7 kg) without
batteries and 16.9 lbs (7.7 kg) with batteries. Use the monitor's handle
when lifting or carrying the monitor. You may need to support the
bottom of the monitor with your other hand.
Caution
If the monitor falls or is dropped, check the display for any cracks. If
the display is broken contact your biomedical department or local state
environmental personnel for proper disposal.
Note— At this time, Philips Medical Systems will make available on
request, and in English only, such circuit diagrams, component part lists,
descriptions, calibration instructions or other information which will
assist the user's appropriate qualified technical personnel to repair those
parts of the equipment which are classified by Philips Medical Systems
to be repairable.