Philips V24CT - Manual (Page 212)

Additional Information
6-40 Recording Functions
Re
c
o
rd
ing
Func
tions
For example, the complete code (8AMIN360) at the beginning of a
recording strip means:
The recording is delayed (8A).
The monitor is in monitoring mode (M).
The application area is ICU (I).
The patient type is neonatal (N).
The delay time is 6 minutes, and the recording is an oxyCRG one
(360).
Realtime and delayed recordings are also annotated with the following
information:
• Date and time (time of the alarm for alarm recordings, time of
request for delayed recordings, time data was measured for stored
recordings such as cardiac output, and time when run for others).
• Alarm/INOP text (if applicable)
• Patient parameters
• Recorder speed
• Waveform labels
• Scale lines and labels
• Bed label and patient name (if the monitor is attached to the
Philips patient care system, or if the patient data management
option has been purchased).
Note— For recordings made at speeds lower than 6.25 mm/s, the time is
updated every 15 minutes. If you are making a continuous realtime
recording at these speeds on the 4-channel recorder, the recording is
started at 25 mm/s for the calibration marks and annotations, then
switched to the configured speed. No re-annotations are made.
Recordings made at speeds greater or equal to 6.25 mm/s are annotated
every 60 seconds on the Plug-In and 4-channel recorders. There is no re-
annotation on central station recorders.
A calibration pulse scale is included for ECG, pressure, CO
2
, EEG and
VueLink waveforms. This annotation appears above the waveform. For
cardiac output recordings, the calibration annotation takes the form: