Philips V24CT - Manual (Page 216)

Additional Information
6-44 Recording Functions
Re
c
o
rd
ing
Func
tions
Inserting a
Calibration
Signal You can insert a calibration signal into the waveform display on the
monitor and into any actively running recording. Calibration signals are
automatically generated for calibrated waves. The signals can then be
used to determine the amplification of the waveform.
To insert the signal, press , then . If you
press the softkey at the bottom of the screen, when a
recording is being run, the signal appears on the display and is inserted
in the recording. Refer to Chapter 3, “Setting up your Monitor” for
further details.
Recording
Layouts Layout Choices on Recorder M1116A/B
1
Alarm recordings always use layout #1, even if the delayed recordings
are configured with layout #2, 3, or 4.
Trends/Calcs Mark Event
Cal Signals
Layout Sector 1 Sector 2
#1
1
20 mm
Wave 1 20 mm
Wave 2
#2 40 mm
Wave 1,2
#3 20 mm
Wave 1 20 mm
Wave 2,3;
#4 40 mm
Waves 1-3