Star Micronics Line Thermal Printer - Manual (Page 93)

―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 3-77
ESC FF NUL
[Name] Execute FF mode
[Code]
ASCII ESC FF NUL
Hex. 1B 0C 00
Decimal 27 12 0
[Defined Area]
- - -
[Initial Value] - - -
[Function] Executes FF mode.
Executes operation specified by the FF mode setting command (ESC * r F n NUL).
ESC FF EOT
[Name] Execute EOT mode
[Code] ASCII ESC FF EOT
Hex. 1B 0C 04
Decimal 27 12 4
[Defined Area]
- - -
[Initial Value] - - -
[Function] Executes EOT mode.
Executes operation specified by the EOT mode setting command (ESC * r E n NUL).
ESC * r N n NUL
[Name] Discard data for specified byte count
[Code]
ASCII ESC * r N n NUL
Hex. 1B 2A 72 4E n 0
Decimal 27 42 114 78 n 0
[Defined Area]
1 ≤ n ≤ 2 5 5
[Initial Value] - - -
[Function] Discards data for the specified byte count.
Discards data received after a byte count specified by n.
n is expressed in decimal (maximum 4 digits) using ASCII characters.
This command is effective only in raster mode.