Star Micronics Line Thermal Printer - Manual (Page 122)

―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 3-106
ESC GS / 2 n
[Name] Set command character
[Code] ASCII ESC GS / 3 n
Hex. 1b 1d 2f 32 n
Decimal 27 29 47 50 n
[Defined Area]
32 ≤ n ≤ 127, n = 0
[Initial Value] n = 0
[Function] Sets the Auto Logo function command character.
This command is registered to the non-volatile memory by the “ / W” command.
This command is ignored when Auto Logo is being executed.
n Setting
32 to 127 Command Character
0 No Command Character Setting
A command character is a character that is a command for specifying the logo number to print with
the Auto Logo printing.
When “/” is specified as the command character, “/2/3” is embedded in the print data.
The printer does not process the “/” as character data but as a command and stores number that
follows at the end and prints it as an Auto Logo in the order that it is stored. Therefore, if “/2/3” is
embedded, Auto Logo will print Logo2 and Logo3 in that order. If the specified logo has not been
registered, logo printing will be ignored.
Also, if there is no set command character setting, a logo will not be printed.
Note that “/2/3” is processed as a command is not printed.
However, using the “ /5 n ” command it is possible to switch “/2/3” to a space.
In the same way as with “/2/3/2/2” if a logo is duplicated, only the initial logo is printed.
A maximum of 32 logos can be stored as Auto Logos.
Continuing after the command character, the following shows the defined area of the character d
that specifies the logo number.
“1” ≤ d ≤ “9” (49 ≤ d ≤ 57) → Logo number 1 to 9
“A” ≤ d ≤ “F” (65 ≤ d ≤ 70) → Logo number 10 to 16