Star Micronics Line Thermal Printer - Manual (Page 120)

―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 3-104
ESC GS / W
[Name] Register Auto Logo setting to non-volatile memory
[Code] ASCII ESC GS / W
Hex. 1b 1d 2f 57
Decimal 27 29 47 87
[Defined Area]
- - -
[Initial Value] - - -
[Function] Registers Auto Logo setting to non-volatile memory
After registration, the printer is reset.
This command is ignored when Auto Logo is being executed.
ESC GS / C
[Name] Initialize Auto Logo setting to non-volatile memory
[Code] ASCII ESC GS / C
Hex. 1b 1d 2f 43
Decimal 27 29 47 67
[Defined Area]
- - -
[Initial Value] - - -
[Function] Initializes registered data in the non-volatile memory of the Auto Logo function.
After initialization, the printer is reset.
This command is ignored when Auto Logo is being executed.
The default values of the Auto Logo function are below.
Setting Initial Value
Auto Logo Function OFF
Command Character None
User Macro 1 None
User Macro 2 None
Command Character Switch No print
Partial Cut Before Auto Logo Printing Disabled