Star Micronics Line Thermal Printer - Manual (Page 159)

―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 5-18
• TSP700II
Counter Type
Maintenance
Counter
Estimated Life
Count Up
Predetermined
Times
Counter
Maximum Value
EEPROM Writing Timing
Permanent
Counter Head
Energizing
Count 800 Million
dot lines For each
4,000 dot
lines (500
mm) 0xF4240 (1
Million) • When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
LF Motor
Traveling
Distance
100 km; 800
Million dot
lines For each
4,000 dot
lines (500
mm) 0xF4240 (1
Million) • When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
Cutter Drive
Count
200,000 cuts Every 10 cuts 0xF4240 (1
Million)
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
User Counter Head
Energizing
Count
800 Million
dot lines For each
4,000 dot
lines (500
mm) 0xF4240 (1
Million) • When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
LF Motor
Traveling
Distance
100 km; 800
Million dot
lines For each
4,000 dot
lines (500
mm) 0xF4240 (1
Million) • When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
Cutter Drive
Count
200,000 cuts Every 10 cuts 0xF4240 (1
Million)
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the count up
predetermined count is exceeded.
• The head energizing count is sometimes counted even when there is not energizing data. (Such as when
blank space data is included in the font data.)
• The estimated life prescribes the number of count of the maintenance counter. It does not match the life
specifications.
• When the permanent counter exceeds the counter maximum value, thereafter the permanent counter
and user counter both count up and then stop.
• It is possible to clear the user counter, but it is not possible to clear the permanent counter.