Star Micronics Line Thermal Printer - Manual (Page 131)

―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 3-115
3.12. Details of the Print Starting Trigger Control Command
This command is for models equipped with an expansion control function for page control of line unit commands, by
controlling the image buffer by page.
ESC GS g 0 m n
[Name] Print starting trigger
[Code] ASCII ESC GS g 0 m n
Hex. 1B 1D 67 30 m n
Decimal 27 29 103 48 m n
[Defined Area] m = 0, n = 0
[Initial Value] ---
[Function] Starts printing when there is unprinted data in the image buffer.
It is prohibited to send this command while in the raster mode.
ESC GS g 1 m n
[Name] Print starting timer
[Code] ASCII ESC GS g 1 m n
Hex. 1B 1D 67 31 m n
Decimal 27 29 103 49 m n
[Defined Area] m = 0, 0 ≤ n ≤ 255
[Initial Value] Depends on the model
[Function] Sets the print starting timer specified at n x 10 msec.
The print starting timer starts measuring from the point where the print data reception stops, and
measures up to the set print starting timer.
When the set print starting timer is reached, the printer starts printing if there is unprinted data in
the image buffer.
It is prohibited to send this command while in the raster mode.
n Operating Mode
0 Print starting timer = initial value
1 to 255 Print starting timer n x 10 msec.