Muratec MFX-1300/1700 User Manual

Page 93

Advanced features

Press

ENTER

.The

LCD

now shows either:

Use the numeric keypad to enter the number exactly as your machine should dial
it, including whatever codes your phone system requires. The number can be up
to 40 characters in length:

Your display shows only 20 characters at a time. To view characters beyond those
20, press to

scroll to the left or

to scroll to the right.

Important:

Do not press

ENTER

Next, while you can still see the fax number on the

LCD

,press

A D VA N C E D F U N C

TIONS

twice and then press

ENTER

If you want the polling to begin immediately every time you press the key, press

ENTER

and skip to step 12.

If you want to delay the polling, press

A D VA N C E D FUNCTIONS

ENTER

Next, tell your fax to carry out this delayed command one of these ways:

Option 1:

Perform the command once at a certain time on a certain day of
the month. (For example, Do this at 5:05

P M

on the 30th. )

To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:

Option 2:

Perform the command at a certain time each day you press the
key.(For example, Do this at 5:05

P M

today.)

To select this option, use the numeric keypad to enter 0, 0 and then
the time the fax should perform the command:

Press

ENTER

Press

STO P

to return your machine to standby mode.

Programming an F-Code transmission

For this operation to work, two things must be true:

You must know how the remote fax is using each F-Code box to which you re trans-
mitting for example, as a security box or a relay box. Different fax manufacturers
may use slightly different terms, but the concepts are the same.

You must know the remote fax s

ITU

sub-address and password for each box to

which you want to transmit.

To program an F-Code transmission into a programmable one-touch key:

Press Program key,

, 3, 0, 1,

ENTER

.The

LCD

shows the first empty programma-

ble one-touch number available:

Note:

P2 appears on the

LCD

, it means that you have already entered a num-

ber for P1.

You can see what you programmed into P1 by pressing , if

you want. For example, if you set P1 for storing of the polling document,
you will see:

Press to

back to the programmable one-touch key you want to

enter.

Note:

To erase a programmable one-touch key, see page 3.48.

Press the key that you want to program or change. Here, we ve selected P2.

Note:

If your previous command for this key was for an F-Code transmission
and you want to keep this key programmed for an F-Code transmission,
use these instructions to make changes. But if you want to assign this
key to a completely different operation (for a delayed transmission, for
example), then you first must erase the stored command before program-
ming the new one.

If you want to select a different programmable one-touch key than the one that
appears on the

LCD

, press that key now.

Press

ENTER

.The

LCD

asks which operation you want to program into the pro-

grammable one-touch:

Type :Communication

/Enter

Select Program No.
P2:No Number Stored

Select Program No.
P1:Polling Document

Select Program No.
P2:No Number Stored

Delayed
Enter Time: 00/17:05

Delayed
Enter Time: 30/17:05

P2:Fax#/Advan.Func.
9-5550696_

P2:Fax#/Advan.Func.
9-5558743_

P2:Fax#/Advan.Func.
_

3.40